Peter, Author at NetworkingNexus.net

Configuring Alcatel-Lucent switches

The following configuration enables sFlow monitoring of all interfaces on an Alcatel-Lucent OmniSwitch switch (10.0.0.235), sampling packets at 1-in-512, polling counters every 30 seconds and sending the sFlow to an analyzer (10.0.0.1) on UDP port 6343 (the default sFlow port):

sflow agent ip 10.0.0.235
sflow receiver 1 name InMon address 10.0.0.1 udp-port 6343
sflow sampler 1 port 1/1-20 receiver 1 rate 512
sflow poller 1 port 1/1-20 receiver 1 interval 30

The switches also support the sFlow MIB for configuration.

See Trying out sFlow for suggestions on getting started with sFlow monitoring and reporting.

OpenDaylight

This article looks takes the DDoS example and repeats it using the OpenDaylight controller.

First install Open Daylight in the Mininet testbed.

$ wget https://jenkins.opendaylight.org/controller/job/controller-merge/lastSuccessfulBuild/artifact/opendaylight/distribution/opendaylight/target/distribution.opendaylight-osgipackage.zip
unzip distribution.opendaylight-osgipackage.zip

Next start Mininet.

sudo mn --topo single,3 --controller=remote,ip=127.0.0.1

Enable sFlow on the switch:

sudo ovs-vsctl -- --id=@sflow create sflow agent=eth0  target="127.0.0.1:6343" sampling=10 polling=20 -- -- set bridge s1 sflow=@sflow

Start OpenDaylight.

cd opendaylight
./run.sh

Confirm that the controller is running and has discovered the switch by connecting a browser to port 8080 on the testbed - the screen shot at the start of the article shows the OpenDaylight Devices tab with the switch 00:00:00:00:00:00:00:01 shown in the Nodes Learned list and in the map (the default credentials to log into the OpenDaylight interface are User:admin, Password:admin).

The following sFlow-RT script modified the original to use the OpenDaylight Flow Programmer REST API to push OpenFlow rules to the switch.

include('extras/json2.js');

var flowkeys = 'ipsource';
var value = 'frames';
var filter = 'outputifindex!=discard&direction=ingress&sourcegroup=external';
var threshold = 1000;
var groups = {'external':['0.0.0.0/0'],'internal':['10.0.0.2/32']};

var metricName = 'ddos';
var controls = {};
var enabled = true;
var  Continue reading