Iwan Rahabok sent me a link to a nice vRealize setup he put together to measure maximum utilization across all uplinks of a VMware host. Pretty handy when the virtualization people start deploying servers with two 10GE uplinks with all sorts of traffic haphazardly assigned to one or both of them.
Oh, if the previous paragraph sounds like Latin, and you should know a bit about vSphere/ESXi, take a hefty dose of my vSphere 6 webinar ;)
Are you attending HIMSS 2015 in Chicago? We’ll be there with our newest partner! This week we announced our partnership with PSSC Labs. This partnership combines Plexxi’s SDN switching and control with PSSC’s high-performance compute and Cloudera enterprise. We’ll be showcasing the integrated solution, called the CloudOOP Big Data Pod, for the first time April 12 – 16 at HIMSS 2015. We’ll also be demonstrating how to effectively manage Big Data applications across a Hadoop cluster. Visit us at the PSSC Labs booth (#5284). We can’t wait to see you.
Below please find a few of our top picks for our favorite news articles of the week. Enjoy!
TechTarget: How SDN and SDS are shaping future clouds
By Jim O’Reilly
Tenants of clouds, whether public or hybrid, want the control mechanisms of a typical in-house data center. They don’t want to give up on virtual storage area networks and firewalls, access controls, governance and compliance and all the other security and control systems that go with ownership. But, at the same time, they want to see the promised agility, rapid scaling and cost effectiveness that brought them to the cloud in the first place.
Enterprise Networking Planet: The SDN-IoT Connection
Continue reading
Startup Avi Networks plans to push Layer 4-7 into the SDN age.
Did you miss out all the SDx news this week? No worries, it's all right here for you.
How to effectively embed SDN for a successful implementation.
I occasionally run into Cisco ASAs that don’t identify their status (active/standby). This is rectified by configuring the “prompt “. These are:
asa-1-pri(config)# prompt ?
configure mode commands/options:
context Display the context in the session prompt (multimode only)
domain Display the domain in the session prompt
hostname Display the hostname in the session prompt
priority Display the priority in the session prompt
state Display the traffic passing state in the session prompt
“state” will tell you if the device is active or standby.
You can check what’s currently on the ASA with:
asa-1-pri# show run prompt
prompt hostname context